| Marker studs : |
These studs, fitted to the push-connectors, are used to identify the service lines (blue stud) and PCM lines (yellow stud).
|
| Push-connectors : |
red push-connectors,
replacement push-connectors.
|
| Grease caps : |
The grease caps guarantee the reliability of the connection contact. |
| Waterproofing kit : |
This waterproofing kit is used to provide protection for the multi-pair cable at the point where it is divided.
It is composed of a sleeve, a bag of resin and a pair of gloves.
|
| Blocs for 4x25 pairs in a kit : |
Kit of 4 x 25-pair blocks without grease caps. |
| One-pair test prod, with or without lead : |
This prod is mounted on the push-connectors and is used to measure the potential on each contact. The 1.5-metre flexible lead is terminated in 4 mm male and female banana plugs.
|
| Test shoes : |
These test shoes are used to test the multi-pair cables after connection. They are mounted on the front panel of the TFSR heads, with no need for disconnection.
These shoes are supplied in a 25-pair version for manual tests and 25-pair version for automatic tests.
They are connected to an automatic Tactel or Sefelec tester. Two shoes are used together to test 50 pairs.
|
| Storage comb : |
This is used to position the jumpers at the bottom of the channel located between the rows of push-connectors. |
| Cabling tool : |
This tool is used for insertion , cutting of excess length, and extraction of the cabling wires |
